4 May
2020
4 May
'20
4:26 p.m.
Probably the issue is becouse DECNET is not started or no license PAK for UCX/DECNET.
Try $ start/network decnet
Decnet is started in a COM file, located: sys$manager:vmstartup_vms.com
(somewhere at the bottom of the file)
start decnet manualy and then go with citcuits...
regards,
Ales
----- Original Message -----
From: "Serguei" <melehov at sypp.ru>
To: hecnet at Update.UU.SE
Sent: Monday, May 4, 2020 4:21:21 PM
Subject: Re: [HECnet] MULTINET + DECnet over ip
Hi,
?Sorry i was in hurry. didn't make it clean enough
?Problem that after
@DECNET-CIRCUITS.COM
it says
MultiNet: DECnet not started; not starting DECnet over IP circuits
so seems
multinet set/decnet/remote=pdp-11.online /device=tcpa0: /connect /tcp=connect /buffers=24
not working and
it falls down into error here
If F$GetDVI("_NET0:","EXISTS") Then Goto DECnet_Ok $ Write
Sys$Output "MultiNet: DECnet not started; not starting DECnet over IP circuits"
But why? No any other errors occurs
tcpa0: is seen in list of devices
Serg
04.05.2020 17:03, ales.petan at digital.si ?????:
Have you solved the problem ?
-----Original Message-----
From: owner-hecnet at Update.UU.SE <owner-hecnet at Update.UU.SE> On Behalf Of
Serguei
Sent: Monday, May 4, 2020 8:59 AM
To: hecnet at Update.UU.SE
Subject: [HECnet] MULTINET + DECnet over ip
Hello,
I finally won in battle on getting up OpenVMS on simh + multinet 5.4
But now i have problem
part of DECNET-CIRCUITS.COM :
$ SysGen:=$SysGen
$ SysGen Load Multinet:TCPDriver
$ sysgen connect tcpa0:/noadapter/driver=tcpdriver $ multinet set/decnet/remote=X.X.X.X
/device=tcpa0: /connect /tcp=connect /buffers=24 $ If
F$GetDVI("_NET0:","EXISTS") Then Goto DECnet_Ok $ Write Sys$Output
"MultiNet: DECnet not started; not starting DECnet over IP circuits"
$ Exit
$DECnet_Ok:
$ mcr ncp
set line TCP-0-0 state on
set circuit TCP-0-0 state on cost 1 hello timer 15
$ @DECNET-CIRCUITS.COM
MultiNet: DECnet not started; not starting DECnet over IP circuits $ multinet ping
pdp-11.online PING PDP-11.ONLINE (X.X.X.X): 56 data bytes
64 bytes from X.X.X.X: icmp_seq=0 time=50 ms
64 bytes from X.X.X.X: icmp_seq=1 time=50 ms
seems like multinet set/decnet/remote=X.X.X.X /device=tcpa0: /connect /tcp=connect
/buffers=24 not creates _NET0: device. but no errors is displayed. Anyone knows what could
be problem?
Yours,
Serguei
http://dec-center.ru
--
??? ????????? ????????? ?? ?????? ??????????? Avast.
https://www.avast.com/antivirus
--
??? ????????? ????????? ?? ?????? ??????????? Avast.
https://www.avast.com/antivirus