17 May
2024
17 May
'24
8:21 p.m.
7-1-CONFIG is what SETSPD parses and DECNET cannot come up until SETSPD
has completed. The Ethernet address is set during this time.
I'm unaware of NODE.IND; you have to specify the node in the 7-1-CONFIG
file, although I suppose you could run a separate instance of SETSPD to
process it.
After the system is up, SETNOD is run to do a bulk load of DECnet nodes
into the Tops-20 node hash table. SETNOD has no code to set the
executor node nor any of the other parameters that SETSPD can set for
DECNET.
On 5/17/24 1:56 PM, Anders Andersson wrote:
Asto that question however, the network configuration
looks as follows:
devdef ni0 564 ni20 dedic=true ifc=tap2 ifmeth=tap+bridge ipaddr=192.168.9.72
dpdelay=3
then I havea local file in SYSTEM with the node number used by 7-CONFIG.CMD
which I believe makes KLH10 set the correct ethernet address on its inerface.
$TYPE (FILE) NODE.IND.1
RARITY 1.802
/Anders Andersson
HECnet mailing list --hecnet(a)lists.dfupdate.se
To unsubscribe send an email tohecnet-leave(a)lists.dfupdate.se