On 2014-05-20 19:47, Cory Smelosky wrote: Well, I'm just not having ANY luck with this... VMR @SYSVMR VMR -- *DIAG*-Partition reduced to executive common size INS EXCOM1 VMR -- *DIAG*-Partition reduced to executive common size INS EXCOM2 VMR -- *DIAG*-Loadable driver larger than 4K LOA TT: VMR -- *DIAG*-Installed tasks may no longer fit in partition SET /TOP=DRVPAR:-* POOL=1200:9644.:09644. (That bit is understandable. I must've configured it too big!) They are diagnostic messages, and many times totally expected and normal. The TT: driver is definitely expected. (I would be very worried if you did not get that one.) Same with the DRVPAR shrinking. It's a warning that is not important here, as you do not use DRVPAR for dynamic tasks anyway. The EXCOMn partitions are an 11M thing, but as far as I can remember they are also totally expected. boo [1,54]rsx11m SYSTEM CRASH AT LOCATION 014402 REGISTERS R0=000002 R1=120550 R2=000000 R3=120546 R4=120744 R5=031610 SP=117772 PS=020010 SYSTEM STACK DUMP LOCATION CONTENTS 117772 000004 001344 That is a very weird and unexpected stack pointer. RSX normally have the stack in rather low addresses. Not sure exactly what you configured, but maybe something wrong in all your answers... :-) After reboot: boo [1.54]rsx11m MCR -- Task not in system ins $boo boo [1,54]rsx11,\,\m [no output] I seem to be TERRIBLE and SYSGEN. Well, since the initial boot failed, any subsequent boots of that image I would expect to fail equally bad. Johnny