SIMH VAX Project - HECnet

1 Jul 2011

Seconded - I run GORVAX's SIMH in a screen..

Sampsa

On 1 Jul 2011, at 00:10, Jason Stevens wrote:
I always like to run them from screen.. Then you can attach to the console etc etc...  

On Thu, Jun 30, 2011 at 6:09 PM, Steve Davidson <jeep at scshome.net> wrote:
Mark,

This is a VERY easy setup.   Start your SimH process from rc.local.   Be sure to put the
"&" at the end of the line.   I can send you what I have if need be.

Regards,

-Steve

-----Original Message-----
From: owner-hecnet at Update.UU.SE on behalf of Mark Benson
Sent: Thu 6/30/2011 08:57
To: hecnet at Update.UU.SE

Subject: Re: [HECnet] SIMH VAX Project

...
  Security on BSD distributions is tight, you might need
to reduce the security policies on the system. Libpcap turns the ethernet device in
promiscuous mode and that may be considered harmful. 
Figures. You can only run SIMH with networking as root. Might explain it.

--
Mark Benson

http://markbenson.org/blog
http://twitter.com/MDBenson

On 30 Jun 2011, at 10:56, hvlems at zonnet.nl wrote:

...

 Hans
 Verzonden vanaf mijn draadloze BlackBerry  -toestel

 -----Original Message-----
 From: Mark Benson <md.benson at gmail.com>
 Sender: owner-hecnet at Update.UU.SE
 Date: Thu, 30 Jun 2011 10:26:19
 To: hecnet at Update.UU.SE<hecnet at Update.UU.SE>
 Reply-To: hecnet at Update.UU.SESubject: Re: [HECnet] SIMH VAX Project

 "File not found" I think. Like it couldn't pick up the device.

 Re: Sharing a port, I don't need to talk to the host OS from the VAX emulation, I
just need to access both from a third host.

 I will have to compile libpcap from pkgsrc but that shouldn't be an issue unless pcap
needs to be present at compile time. If that is the case I just need to recompile SIMH so
again no big deal.

 FWIW, NetBSD is not a flavour of Linux either ;) ;)
 <this is intended as a lighthearted statement>

 It's all good fun!

 --
 Mark Benson

 http://markbenson.org/blog
 http://twitter.com/MDBenson

 On 30 Jun 2011, at 09:53, hvlems at zonnet.nl wrote:

> What error message did you get? 