Yes I hooked up the vms install CDROM to the multia to boot and used the boot procedure with floppy and it pretty much stalls after the "starting bootstrap ..."message. took the HD from the dec3000 with the image of the vms install disk and tried to boot from it with same results. Bought a new (and expensive) floppy for it and same results. Can flip to ARC and SRM consoles ok (not tried to boot under arc as I don't have win nt.) --------- Just booted back up and it was at ARC console so I switched it over to SRM and power cycled it and now it's not powering the monitor. Will have to find my serial cable and try to switch it. Sent from my iPhone On Feb 10, 2013, at 4:06 AM, "Kari Uusim ki" <uusimaki at exdecfinland.org> wrote: > > Do you have any chance to test booting from a directly connected SCSI CD-ROM or a disk? > > > Kari > > > > On 10.2.2013 0:58, Michael Holmes wrote: >> >> >> Forgive me if this is off topic, but I was reading about the fixes to >> the VAXStation 4000 regarding chips. >> >> I bought a multia several years back and I think it sucommed to being >> moved to and from Germany and the States too many times. >> >> I had it booting as a satelite off a DEC 3000 just fine, until this last >> move. >> >> I thought the battery had died and replaced it. (dead battery prevents >> the bios from coming up) >> >> I get the SRM console and i'd get MOP load message on the DEC 3000 but >> the MULTIA just hangs after message about bootstrapping. >> >> I heard something about an I/O chip that can go bad on the MB and was >> wondering if anyone had any ideas that could be used to fix the MULTIA. >> >> thanks >> >> Mike >