On Wed, Mar 28, 2012 at 05:34:07AM -0400, Brian Hechinger wrote: I'm working with getting the 4000/90 up and running and I was wondering if anyone had seen this behavior before. Upon initial power up all the diag lights are lit and nothing ever happens. If I quickly flip the power switch off and on it then comes up normally. This happens every time it's powered on cold. Once it's on as long as I only ever quickly flick the power switch off and on it works fine. Thoughts? Incidentally, Holm Tilfe over att cctech@ had a similar problem. His problem description: The Machine doesn't start properly if it is switched on, the LEDs are all stuck on (0xff). If I switch it off then and on again in a short time, it starts up properly, is doing the diagnostics and tries to boot an (defective?) NetBSD 1.1 that is loading the kernel but is getting then in a ?54 RETRY loop. His solution was as follows: Ok, answering myself: Yes this error is already known, found a thread in comp.sys.dec. The cause ist an empty lithium cell in the DS1287A RTC. Used a proxxon grindng tool and grinded the IC housing of, replaced the empty cell (1,07V) with an soldered on CR2016. Works now. The RTC was unable to remember the "set bootdev dka0" over a powercycle. Hope it helps, Pontus