I have published everything up on CodePlex now. Here is the link: https://route20.codeplex.com/ Regards Rob -----Original Message----- From: owner-hecnet at Update.UU.SE [mailto:owner-hecnet at Update.UU.SE] On Behalf Of Brian Hechinger Sent: 08 September 2012 00:38 To: hecnet at Update.UU.SE Subject: Re: [HECnet] Beta User Mode DECnet Router Available For Testing Ok, but where do we find the source? :) -brian On 9/7/2012 6:36 PM, Rob Jarratt wrote: I am ready for a couple of people to try out the user mode DECnet router I have been writing. Is anyone interested in trying it out? You will need to be able to compile C code and have pcap or winpcap installed. Here is an extract from the README: User Mode DECnet Router Readme ============================== This program is a DECnet router that implements version 2.0 of the DECnet routing specification found here: http://linux-decnet.sourceforge.net/docs/route20.txt Features -------- 1. Runs on Windows either as a Windows Service, or as a console program. 2. Runs on Linux as a daemon. 3. Full routing capability, so it avoids broadcasting all routing messages to entire network and kills looping packets. 4. Supports Ethernet (using pcap/winpcap). 5. Supports Johnny's bridge. 6. Can be extended to support other kinds of circuit (Cisco and Multinet might be examples, not tried). 7. Does dynamic DNS updates without blocking. Limitations ----------- 1. Only tested on Windows Server 2003 and Raspberry Pi running Debian. 2. Does not support Phase III nodes. 3. Although it can be configured as a Level 1 node, Level 1 is not fully supported. It has only been tested as a Level 2 (area router) node. 4. Limited testing on Raspberry Pi. 5. Performance not tested. 6. Not tested with multiple ethernets. 7. Limited testing with multiple bridges. Regards Rob