On 2012-09-18 02:47, Dave McGuire wrote: On 09/17/2012 06:36 PM, Dan Williams wrote: No it's not getting that far Anything on the first serial port? It has been awhile, but I seem to recall it prints out some messages there on (or just after) startup. If you have a terminal attached to port 1, and have it set to ignore the modem signals, and the correct speed (probably 1200 bps, but I might be wrong), it will print out some informational messages during self test and as it tries to boot. To actually have it boot you need a MOP server on the network, and the right image. PR0801ENG.SYS, if I remember right... If you are on HECnet, and the MOP protocol is enabled (for both sides), MIM will serve the boot image for you. Johnny -- Johnny Billquist || "I'm on a bus || on a psychedelic trip email: bqt at softjar.se || Reading murder books pdp is alive! || tryin' to stay hip" - B. Idol