The KZPSA is a differential scsi controller. It supports dual hosts and may be used as a cluster interconnect (data only, no cluster control messages). ------Origineel bericht------ Van: Peter Coghlan Afzender: owner-hecnet at Update.UU.SE Aan: hecnet at Update.UU.SE Beantwoorden: hecnet at Update.UU.SE Onderwerp: Re: [HECnet] And yet more begging: KZPAC style controller? Verzonden: 6 september 2011 00:49 Here's a photo of mine, can you draw the bit I need to change onto it, or the general area: http://sampsa.com/wp-content/kzstyleboard.jpg That picture reminded me of something. I have what I thought was an extra long and overly complex PCI SCSI card in my stash. It has the same Intel i960 as the card in the picture but doesn't have the extra daughter board. It is marked KZPSAPS and has a single 68 pin external SCSI connector and five resistor packs commonly found as terminators on old-style (ie non-low-voltage) differential SCSI cards. I tried firing it up in my AS1000A and found that SRM sees it as follows: SHOW CONF 12 DEC KZPSA pke0.7.0.12.0 SCSI Bus ID 7 SHOW DEV pke0.7.0.12.0 PKE0 SCSI Bus ID 7 R01 A11 VMS (7.1-2) sees it as: Device PKA0:, device type KZTSA/SCSI (SIMport), is online, error logging is enabled. Error count 0 Operations completed 24 Owner process "" Owner UIC [SYSTEM] Owner process ID 00000000 Dev Prot S:RWPL,O:RWPL,G,W Reference count 0 Default buffer size 0 Anyone know what (if anything) is special about this card? Regards, Peter Coghlan. Verzonden vanaf mijn draadloze BlackBerry -toestel