Hmm... For 1., I would just hook up getty or something on the linux box and have it automatically connect to the TCP serial port on the VAX. For 2, not sure, but it's not brain surgery writing something that reads from a /dev/tty* and writes to a TCP socket. Could probably use the same little bit of code to accomplish both... Sampsa On 16 Jul 2010, at 21:28, Joe Ferraro wrote: 1.) hooking a vt up to the host linux box to access the VAX 2.) seeing if I could pass inbound serial data from a [serial] scanner to software on the emulated vax I know.. sounds silly... On Fri, Jul 16, 2010 at 4:14 PM, Sampsa Laine <sampsa at mac.com> wrote: Not much no, AFAIK the serial ports on SIMH VAX just expose themselves to the outside world as a TCP socket (listening inbound only, again as far as I can tell)... What are you planning on doing? Sampsa On 16 Jul 2010, at 21:10, Joe Ferraro wrote: Already done, my friend... it should be in the latest push... Ever done much serial (e.g. RS-232 and the like) programming? If so, do you know of any good references? I'd like to see if I can interface with the serial ports on a simh vax... Cheers... On Fri, Jul 16, 2010 at 4:06 PM, Sampsa Laine <sampsa at mac.com> wrote: OK, Cool, you need to let Johnny know so he can update the master node name database as well. Sampsa On 16 Jul 2010, at 21:02, Joe Ferraro wrote: Sampsa, I'm sure you've already realized via update, but I was just thinking that I forgot to mention it to you -- I've taken area 20 so as to be able to give you back your node addresses. I think I had the 8.50n series... Also, I have taylor up on solaris 10.. just need to configure it... Joe On Fri, Jul 16, 2010 at 1:26 PM, Sampsa Laine <msampsa at mac.co> wrote: Guys/Johnny, I'm registering two new nodes in my area, BONZO and LEMUR. BONZO is at 8.800 LEMUR is at 8.430 Sampsa On 16 Jul 2010, at 18:08, Marc Chametzky wrote: Have you ever run an Alpha with only 128MB of RAM? That is the absolute bare minimum I'd run 7.2 in, and it wasn't fun. I really wish they'd allow between 192MB and 256MB, as at that point it starts being usable. Of course I'd also like a Linux version. :-) They have a Linux version called CHARON-AXP/ES40 for Linux NCE. You can find it at http://www.stromasys.ch/axpnce/ . I've set it up here and it does work. The only downside is that the non-commercial (free) version shuts off after 30 days requiring a restart. Plus, it's time-bombed to stop working after December 31, 2010 (although a newer version should subsequently be available if past history continues). --Marc