Hi Johnny! No stress. I was just overly enthusiastic. Al -----Original Message----- From: owner-hecnet at Update.UU.SE [mailto:owner-hecnet at Update.UU.SE] On Behalf Of Johnny Billquist Sent: Saturday, 28 April 2012 8:22 PM To: hecnet at Update.UU.SE Subject: Re: [HECnet] Config Sorry, Alastair. I've been rather busy, but I did see your mails. I'll get to it later today, I hope. Anyway, the config looks ok. If you are available later today/tonight, we could try get you up and running... Johnny On 2012-04-26 02:57, Boyanich, Alastair wrote: G'day, I'll send here because I suspect my emails late last week to Mr Bilquist may have been consigned to a junk mail folder. I wanted to (please) apply for a HECnet address initially for one my main VAX at home, later the 11's after I get some more time to work on the hardware. I managed to get the bridge software to compile under IRIX 6.5.29 via GCC 4.6. MIPSPro refused with a couple of trivial errors. I believe I have the config file correctly set up and the ports. The relevant bits of my conf look like: !START [bridge] local ec0 update tempo.update.uu.se:4711 [decnet] local update [lat] local update !EOF Port 4711 is forwarded to my system correctly through firewalls. My external static ip is 202.168.106.176/ns4.reboot.net.au Suggestions/constructive abuse welcome :) Regards, Al. -- Johnny Billquist || "I'm on a bus || on a psychedelic trip email: bqt at softjar.se || Reading murder books pdp is alive! || tryin' to stay hip" - B. Idol