On Thu, 22 May 2014, Johnny Billquist wrote: On 2014-05-22 14:57, Johnny Billquist wrote: On 2014-05-22 14:52, Cory Smelosky wrote: On Thu, 22 May 2014, Cory Smelosky wrote: With the board in I can get to ODT...but: QBUS BUS CONTROLLER TEST#1.......................... FAILED *** FAILED DUE TO UNINITIALIZED Q-BUS MAP, DMA FAILURE OR NON-EXIST MEMORY. QBUS BUS CONTROLLER TEST#2.......................... PASSED QBUS BUS CONTROLLER TEST#3.......................... PASSED QBUS SINGLE WORD DMA TEST........................... PASSED QBUS TO FIFO DMA TEST............................... FAILED *** FAILED DUE TO UNINITIALIZED Q-BUS MAP, DMA FAILURE OR NON-EXIST MEMORY. I think the red ECC error light is on, too but the system IS halted. That sounds bad. What backplane is this sitting in now? And I think the PMI memory board actually do some internal diagnostics already at power on, so an error light on is probably not a good sign... By the way, I hope/assume that you also configured it to start at address 0... I have. Took me a bit to figure out which DIP switch position meant "on" and which meant "off". Johnny -- Cory Smelosky http://gewt.net Personal stuff http://gimme-sympathy.org Projects