On 2013-05-16 22:16, Jordi Guillaumes i Pons wrote: Al 15/05/13 22:52, En/na Cory Smelosky ha escrit: What does it use for network device? It's using the NI right now, as it's KLH10. Speaking of devices... has anyone been succesful configuring KLH10 to use a tap interface? I have not been able to do that, so I have to share the host real ethernet, thus making not posible to run two instances of KLH10 in the same host (unless I run those inside a VM, which is a little bit overkill). Oh, and a weird thing... I have a simulated TOPS-10 under KLH10 with DECNET up and running... but it can talk only to its adjacent nodes. It seems like the routing node (a simh 780 running VMS 4.7) does not route traffic (in either direction) when the destination or the source is the KLH10... Weird. Are you sure it talks ok with the routing node? I mean, have you actually used any protocol to test, or just noted the adjacency up messages? The reason I ask is that the adjacency up messages are not really enough to be sure that the link really is working. Johnny -- Johnny Billquist || "I'm on a bus || on a psychedelic trip email: bqt at softjar.se || Reading murder books pdp is alive! || tryin' to stay hip" - B. Idol