On 27 Feb 2013, at 16:16, Brian Hechinger <wonko at 4amlunch.net> wrote: That would explain why I can't push a config to you. :) Yup. ;) It's still running, just not in the correct subnet. It's a slight shame that the catalyst 2820 can't do DECnet or any routing for that matter. I like that switch. -brian On 2/27/2013 4:15 PM, Cory Smelosky wrote: On 27 Feb 2013, at 16:13, Brian Hechinger <wonko at 4amlunch.net> wrote: Or you can go the dynamips/GNS3 route like Cory did. Which will be back up once my network migration is complete. I'm in the middle of moving things to a big Sun and moving to a /16 internally instead of a /24 for administrative reasons. -brian On 2/27/2013 4:12 PM, Ian McLaughlin wrote: Excellent work! I think this tool is a great asset to HECnet. We just need a bit of promotion now. People are scared of Cisco equipment, but you can pick up a low-end router for $50 on ebay and it gives you everything you need to connect to HECnet. Ian On 2013-02-27, at 12:29 PM, Brian Hechinger <wonko at 4amlunch.net> wrote: On 2/27/2013 3:25 PM, Dave McGuire wrote: On 02/27/2013 03:10 PM, Brian Hechinger wrote: The tunnel now does everything in the TODO exact that last one about only sending configs out to only those who need them. It now supports: SNMP is now handled directly in python so no calling external scripts. This allows for much better control over what happens when a router doesn't respond. IPSec tunnels as well as GRE tunnels (well, kinda, I still need to get a working cisco config snippet to use, haven't done that yet) mesh/hub/spoke topology. Each endpoint (router) can be designated one of either hub, mesh or spoke. A spoke will only connect to a hub. hubs and mesh will all connect to each other. That's a damn fine piece of work! Thank you! It's been a blast to write. Much love to Paul for his python assistance. :) -brian --- Filter service subscribers can train this email as spam or not-spam here: http://my.email-as.net/spamham/cgi-bin/learn.pl?messageid=6C0106D8811C11E28…