On Sat, 14 Feb 2015, Peter Lothberg wrote: Put the Panda20 monitor on it ans se if it boots.=20 Getting that on there will be a bit of a challenge however. The MRC's Panda distribution that runs under the KLH-10 emulator, configure a tape drive to write to file. Make yourself a completek boot/distribution tape. Write it to you SCSI tape drive, Johnny had a program. Put the drive on the SC-40 and tell ot to boot from the tape. ...It's been too long since I've touched Panda. ;) KLH10> devmount mta0 tops20.tap Mount requested: "tops20.tap" KLH10> c[mta0: Tape online] ont Continuing KN10 at loc 01142476... $copyy\p\o\ ?No program $rewind mta0: $copy system:monitree\.exe mta0: <SYSTEM>MONITR.EXE.1 => MTA0:MONITR ?Device is write locked: MTA0:MONITR I know I'm doing something wrong to back up the monitor. ;) Back to the manual! I would do this with a copy of your boot-disk, as I don't remember how the console processor file-system got there.. Think it's simular to how it's done on a KS2020. (A file with the FE system and a pointer in the home-block). -P -- Cory Smelosky http://gewt.net Personal stuff http://gimme-sympathy.org Projects