On 15 Jan 2013, at 10:35, Brian Hechinger <wonko at 4amlunch.net> wrote: I will try that but I doubt it'll make any difference. The cisco autodetects 100/full on both of it's virtual interfaces. The AlphaVM-free link to the localhost loopback also comes up 10/half. Is it actually throttling it to 10/half, or is that just a side effect of the card it emulates? -brian On 1/15/2013 10:22 AM, Ian McLaughlin wrote: Have you tried "duplex full" under the "interface" section in your emulated cisco? Ian On 2013-01-15, at 7:13 AM, Brian Hechinger <wonko at 4amlunch.net> wrote: AlphaVM-free on the laptop GNS3 on the laptop Running a virtual cisco 7200 with a tunnel into my "real" router doing decnet routing. I have HECnet connectivity from the alpha! :) $ set host 1.13 Connected to "MIM " However, when I start DECnet I get this message: %EWA0, Half Duplex 10BaseT connection selected I mean, performance isn't terribly important, but I'm just curious if there was something I could do to change that. Emulated adapter on the 7200 is FE, so I wouldn't mind at least that. -brian --- Filter service subscribers can train this email as spam or not-spam here: http://my.email-as.net/spamham/cgi-bin/learn.pl?messageid=2ABE20D85F2611E2A… -- Cory Smelosky http://gewt.net/ Personal stuff! http://gimme-sympathy.org/ My permanently-a-work-in-progress pet project.