El 29/05/2014, a les 19.59, Cory Smelosky <b4 at gewt.net> va escriure: El 29/05/2014, a les 19.56, Cory Smelosky <b4 at gewt.net> va escriure: Can you give an example? I assume you are using CFE to do the definitions. I was using NCP. I had no idea how to define a node any other way due to the fact I have very minimal RAM. With NCP you just can add nodes to the volatile database (SET NODE xxx). You need to use a program named CFERES which lives in [5,54] to do permanent definitions. IIRC you must SET /UIC=[5,54], then RUN CFERES and answer CETAB.MAC to the filename prompt. Then you will get a CFE> prompt and from then you can add your node definitions. (DEFINE NODE xxx). To activate the changes you must reboot RSX (Or perhaps stopping and starting the network is enough, but I'm not sure). Oh, IIRC you can use SET NODE xxxx in CFE, but it acts as a DEFINE NODE anyway. Jordi Guillaumes i Pons jg at jordi.guillaumes.name HECnet: BITXOV::JGUILLAUMES