NETCONFIG pretty much solves all problems... The ethernet interface on a VAXstation 4000 model 60 is recognized by DECnet as ESA0, so you'll see a LINE and a CIRCUIT called ESA-0. The VAXstation 4000 model 90 uses different hardware and the device is known as ISA-0 to DECnet. You can manually create the corresponding LINE and CIRCUIT components with NCP but running NETCONFIG is a lot faster, if not easier ;-) Hans Vlems -----Oorspronkelijk bericht----- Van: owner-hecnet at Update.UU.SE [mailto:owner-hecnet at Update.UU.SE] Namens Mark Wickens Verzonden: zaterdag, mei 2010 11:42 Aan: hecnet at Update.UU.SE Onderwerp: Re: [HECnet] DECNet Issue - moving the system disk between two VMS boxes OK, So in time honoured tradition I solved the problem pretty much by asking the question. I did a NETCONFIG and a reboot and all is fine again. Regards, Mark. Geen virus gevonden in het binnenkomende-bericht. Gecontroleerd door AVG - www.avg.com Versie: 9.0.819 / Virusdatabase: 271.1.1/2889 - datum van uitgifte: 05/22/10 08:26:00