17 Jan
2013
17 Jan
'13
3:26 p.m.
sampsa at mac.com writes:
sampsa at mac.com writes:
On 17 Jan 2013, at 16:02, Cory Smelosky <b4 at gewt.net> wrote:
On 17 Jan 2013, at 08:50, sampsa at mac.com wrote: > >> Strangely enough,
the procedures were working fine for almost the whole day but now I am
getting nothing - no errors, just no connections. >> >> What could cause
this? > > Did the target node crash? ;) > -
Not per se but the DECNET stack got into a pretty bad state - had to
reboot.
I've never had to reboot a VMS box for anything DECnet related.
Yeah, this is some weird interaction between Python and DECNET TASKs.
It refuses to start python, basically.
Can Python be run non-interactively??? Are there any command line flags
or qualifiers for use in non-interactive mode??? Are you trying to pass
commands/data into Python via the DECnet channel??? It appears you are
WRT your SYS$COMMAND definition. Error messages should contain insight!
DECNET boxes seem pretty easy to DOS...
Poor application programming is not the fault of the system it runs on! ;)
A poor application program shouldn't take out the network stack :)
And I doubt that it did...
--
VAXman- A Bored Certified VMS Kernel Mode Hacker VAXman(at)TMESIS(dot)ORG
Well I speak to machines with the voice of humanity.