16 Feb
2013
16 Feb
'13
11:33 p.m.
On Feb 16, 2013, at 4:59 PM, Johnny Billquist wrote:
On 2013-02-16 22:45, Paul_Koning at Dell.com wrote:
On Feb 15, 2013, at 9:24 PM, Johnny Billquist wrote:
On 2013-02-16 03:03, Paul_Koning at Dell.com wrote:
The thing to do would be to see what happens if you load some multicast address (such as
broadcast) into slot 0 of the 16-entry address match table, and the station address into
slot 1. For a QNA, that's perfectly fine because all slots are equivalent and the
device doesn't do any MOP. It may be that this was a later restriction that RSTS
didn't obey. Or it may be a bad assumption in the real LQA that wasn't
documented -- or maybe it's just a bad assumption in the SIMH emulation. I
haven't yet looked for LQA manuals to give more clues.
Ah. I thought you had already checked documentation.
Well, I did now, and simh is right. Page 3-31 of the DELQA manual states that the first
address is used as the source address for system ID messages.
Which edition? I'm looking at EK-DELQA-UG-002 (from Bitsavers) and it can't find
anything like that.
The very same.
Page 3-31, Section 3.6.2.4, third paragraph:
"Any columns not used should be set to the physical address (for better protection
against mischievous Ethernet traffic). More than one physical address may be specified,
but in Normal mode, only the first is used for receiving datagrams, and as the source
address for system ID messages generated by the DELQA."
I read that as "only the first of the several physical addresses is used..." not
"only the address in the first slot". If they intended it to be interpreted as
you did, they sure wrote it badly.
paul