[HECnet] SG1 connectivity

SGC:: is a level 1 router and SGC:: is an area router. SGC:: is functioning normally but SG1:: is not. Apparenty the TOY clock is not functioning. When that happens the default boot device reverts to the Ethernet port. In SG1::'s case, booting using the Ethernet port results in booting into the STRGTE:: cluster for maintenance purposes and no Multinet and no area router. I will try to install/configure Multinet in this variant sometime today - remotely. -Steve Sent from my iPhone On Mar 19, 2015, at 07:18, <Paul_Koning at Dell.com> <Paul_Koning at Dell.com> wrote: On Mar 18, 2015, at 5:00 PM, Jordi Guillaumes i Pons <jg at jordi.guillaumes.name> wrote: ... Now I'm a little bit lost. I think a node must be configured as an Area router to be able to route between two areas via the multinet link. There are two reasons why a node may have to be an area router: 1. If it needs to have other nodes that are in a different area as neighbors 2. If you want to be able to see the area routing tables But if your neighbor is in the same area as you, the whole network is reachable to any node type (endnode, L1 router, area router). The L1 router doesn t have a map of the areas, but instead it sends all out-of-area traffic to the nearest L2 router which is represented in the L1 routing data by the entry for address 0. The datalink type is not a factor here; Multinet is no different from any other point to point link in this respect. paul