[HECnet] DECnet area router configuration

Ian McLaughlin wrote: On 2009-12-03, at 10:49 AM, gerry77 at mail.com <mailto:gerry77 at mail.com> wrote: At the moment I cannot remember if @SYS$MANAGER:NETCONFIG.COM asks something about configuring a node as an area router, but I'm assuming that it doesn't ask anything, or you wouldn't be here asking for help. :-) As a starting point you may just type the following: $ RUN SYS$SYSTEM:NCP NCP> SET EXECUTOR STATE SHUT NCP> DEFINE EXECUTOR TYPE AREA NCP> EXIT $ @SYS$MANAGER:STARTNET If I'm not wrong, this should be enough to transform your node into an area router; then you may want to revise your configuration to tune it better. You are correct - NETCONFIG doesn't ask about level 1 or 2 - just whether you're a router or not. Your commands (which I'm sure I tried some time during the last 24 hours, but I'm not sure) followed by a reboot seems to have fixed it. Thanks! SHOW KNOWN AREAS is showing 9 areas, which is good. SHOW KNOWN NODES isn't showing any new nodes though. And a TELL 1.400 SHOW KNOWN NODES isn't showing my nodes yet. (I'm area 42 if you start seeing it in the node list). At least there's some connectivity. I'll keep working. Thanks for the help. The show known nodes command of course depend on what you mean by known nodes... :-) (See more in my other replies...) Johnny -- Johnny Billquist || "I'm on a bus || on a psychedelic trip email: bqt at softjar.se || Reading murder books pdp is alive! || tryin' to stay hip" - B. Idol