[HECnet] VCF-East on HECnet?

Hi, to all who are interested in trying the new DMC11 network device within the simh prototype (available from Rob, see his mail), here is a short instruction how to configure it under DECnet/VAX: DECnet/VAX Setup for DMC11s If you haven't set up DECnet using netconfig.com yet, so do it now. The netconfig.com command procedure will recognize and set up your DMC11(s) automatically. Otherwise (DECnet already configured, e.g for Ethernet), do: $! ================================================================== $! Setup for two DMC11s, DMC-0 and DMC-1 $! ================================================================== $ RUN SYS$SYSTEM:NCP SET EXECUTOR STATE SHUT DEFINE LINE DMC-0 STATE ON DEFINE CIRCUIT DMC-0 STATE ON COST 5 DEFINE LINE DMC-1 STATE ON DEFINE CIRCUIT DMC-1 STATE ON COST 5 $! $ @SYS$SYSTEM:STARTNET $! That's all! When everything's o.k. (including your network partner's DMC11) the following command should show the line state "on" a while after DECnet has been started: $ MC NCP SHOW KNOWN LINES Known Line Volatile Summary as of 4-NOV-2012 11:22:33 Line State DMC-0 on NCP> More or less unwanted states: DMC-0 on -starting means: still trying to connect to the other side ..., should be gone after a maximum of 30 seconds, otherwise there is a problem DMC-0 on -synchronizing shows up when the other side has been connected, but is not synchronized yet, usually doesn't last longer than a second or two To get rid of one or more DMC11s, just do: $! ================================================================== $! Removal of e.g. second DMC11 DMC-1 $! ================================================================== $ RUN SYS$SYSTEM:NCP SET CIRCUIT DMC-1 STATE OFF PURGE CIRCUIT DMC-1 ALL CLEAR CIRCUIT DMC-1 ALL SET LINE DMC-1 STATE OFF PURGE LINE DMC-1 ALL CLEAR LINE DMC-1 ALL $! Hope this helps - if not, ask for more! Regards, Ulli --- Alle Postf cher an einem Ort. Jetzt wechseln und E-Mail-Adresse mitnehmen! http://email.freenet.de/produkte/basic/index.html