11 Dec
2021
11 Dec
'21
1:19 p.m.
It is the console serial line on the Itanium if I followed this correctly . Some regular
console output may not be redirected and disturb the DDCMP protocol.
Groet,
Wilm
(Verstuurd vanaf mijn telefoon, dus wat korter dan gewoonlijk.)
(Sent from my phone, so a bit more compact than usual)
Op 11 dec. 2021 om 12:55 heeft Johnny Billquist
<bqt at softjar.se> het volgende geschreven:
?On 2021-12-10 20:32, cyb 2600 wrote:
Hello,
A little while ago I purchased an HP BL860c server blade. It has an Itanium 2 CPU and I
was able to install OpenVMS 8.4 on it. However I do NOT have a HP Bladesystem chassis to
put the blade in, meaning I can only connect to it via the SUV console cable which
provides usb, serial, and VGA. There's no way to get ethernet out of the thing without
plugging it into a rather gigantic Bladesystem chassis that I don't have. If it was an
x64 based blade running windows I could just use a USB->Ethernet adapter but of course
those things don't have OpenVMS drivers.
Given ethernet's not an option, would there be any way to tunnel DECNET over the
serial port? It seems like that was possible on VAXen and maybe even Alphas but I've
no mention of doing it on an Itanium. Or if anybody else has any ideas of how I could
network this thing I would appreciate it.
Others have already said a lot. But to just add a little more.
As mentioned, at least on VAXen, you can run DECnet over a serial line. It might very
well be possible also on Alpha and Itanium. Check the docs. Even if it isn't
officially supported, just try turning it on. In VMS, the async DDCMP connections are done
over the normal terminal driver, so I would suspect there is a fair chance it works,
unless they actually ripped that code out.
However, if we talk HECnet, this isn't enough. You then need to get that serial
looped back into something that can connect to some remote side.
My original HECnet links were actually done this way. I had physical serial ports on
machines, then then I had another machine at each end to which the serial ports connected,
and between these two other machines, I ran a simple program that just forwarded the bytes
on the serial ports on both sides.
It worked, but of course this is slow, as it was just 9600 bps. So eventually I wrote my
bridge program to just forward ethernet packets instead.
But in your case, you'd need something like this again. I think you might be able to
just hook it up to PyDECnet. It has DDCMP, and I would hope it could be convinced to talk
over an actual serial port. If it can't, I'm sure Paul could fix that.
Johnny
--
Johnny Billquist || "I'm on a bus
|| on a psychedelic trip
email: bqt at softjar.se || Reading murder books
pdp is alive! || tryin' to stay hip" - B. Idol