[HECnet] Config tool

And done! Sorry for the noise everyone! Reason for change: Modified Tunnel52: Cory Smelosky (Area 9) "dynamic_ip" changed from "true" to false" -brian On Mar 11, 2015, at 10:30 PM, Cory Smelosky <b4 at gewt.net> wrote: On Wed, 11 Mar 2015, Brian Hechinger wrote: Or perhaps not. DNS was saying 139 but it had 132 in the db. I ve manually set it to 139 in the db. If that doesn t settle it down I ll mark you as static. That'd explain things. ;) Good thing it's a 2851 that can take it! Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 15.1(4)M8, RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2014 by Cisco Systems, Inc. Compiled Fri 07-Mar-14 08:19 by prod_rel_team Cisco 2851 (revision 1.0) with 473088K/51200K bytes of memory. Processor board ID FHK1050F1JN 4 FastEthernet interfaces 2 Gigabit Ethernet interfaces 1 Serial interface 1 ATM interface 1 terminal line 1 Virtual Private Network (VPN) Module DRAM configuration is 64 bits wide with parity enabled. 239K bytes of non-volatile configuration memory. 125440K bytes of ATA CompactFlash (Read/Write) Description: LAN :: Link to switch Internet address is 10.10.0.1/16 MTU 9000 bytes, BW 1000000 Kbit/sec, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation 802.1Q Virtual LAN, Vlan ID 1., loopback not set Keepalive set (10 sec) Full Duplex, 1Gbps, media type is T output flow-control is XON, input flow-control is XON Waiting for the gig of RAM to arrive! -- Cory Smelosky http://gewt.net Personal stuff http://gimme-sympathy.org Projects