16 Dec
2021
16 Dec
'21
6:54 p.m.
You may have a license problem.
If you have a DECnet that supports Ethernet, it must be Phase IV (or V, of course). That
means it is required to know about areas. If you have a version that doesn't deal
with areas, either it is terminally broken or it is crippled in a way that disables
multi-area configurations. You'll need to fix that in order to use it on HECnet.
While it's certainly possible to put a Phase III node anywhere in HECnet, with the
reachability limitations that Phase III has, it isn't possible to use a "broken
areas" Phase "IV" node at all. (Well, unless you can connect it into area
1, I suppose.)
paul
On Dec 16, 2021, at 11:08 AM, Supratim Sanyal
<supratim at riseup.net> wrote:
On 12/16/2021 05:41, R. Voorhorst wrote:
Question remains, how did you get Decnet 3.0
running and did you obtain the necessary patch.
Yes, applied the license. I chose
VAX/VMS 3.5 because in March of 2020 you had gone as far as getting a license error on
VMS3.0 that said it needed VMS3.4+. I also tried to use the licensed NETACP.EXE on vms3.0,
does not look promising, says it has problems loading. At this point, Cisco may be the
answer with the nifty feature for DECnet NAT, I will explore it sometime. Anyway, my
experiments are here if you or anyone is interested:
https://www.dropbox.com/sh/x4e6ie4lrwi9wns/AABMogcguAcL8xPwMIDxOtNva?dl=0
On 12/16/2021 04:55, Johnny Billquist wrote:
Uh? The mac address AA-00-04-00-2A-7C means it
has address 31.42. Just sayin...
It's forced at the Linux/SimH level.
On 12/15/2021 20:05, Paul Koning wrote:
You've got to set MAX AREA large enough; 63
is the obvious value. With it not set, the system apparently is defaulting it to 1, so
when you gave it a node address without area number it defaulted the area number to 1,
which of course can't work.
There is no option, at least in NCP, for any Area parameters.
NCP>help set exec
SET
EXECUTOR
Use the SET EXECUTOR command to create or modify parameters in the
volatile database which controls the network on the executor node. Use
the DEFINE EXECUTOR command to create or modify parameters in the
volatile database which controls the network on the executor node.
SET EXECUTOR (parameters ...)
Additional information available:
ALL ADDRESS node-address BROADCAST ROUTING TIMER
BUFFER SIZE number COUNTER TIMER seconds DEFAULT ACCESS
DELAY FACTOR DELAY WEIGHT IDENTIFICATION
INACTIVITY TIMER INCOMING TIMER MAXIMUM ADDRESS
MAXIMUM BROADCAST NONROUTERS MAXIMUM BROADCAST ROUTERS
MAXIMUM BUFFERS MAXIMUM CIRCUITS MAXIMUM COST
MAXIMUM HOPS MAXIMUM LINKS MAXIMUM VISITS
NONPRIVILEGED OUTGOING TIMER PIPELINE QUOTA
PRIVILEGED RETRANSMIT FACTOR ROUTING TIMER
SEGMENT BUFFER SIZE STATE SUBADDRESS range TYPE
Examples NODE
SET EXECUTOR Subtopic?
SET EXECUTOR Subtopic? ex
SET
EXECUTOR
Examples
NCP>SET EXECUTOR ADDRESS 11 BUFFER SIZE 576
This command sets the executor node's address to 11 and buffer
size to 576 bytes.
NCP>SET EXECUTOR STATE ON
This command sets the executor node's operational state to ON.
SET EXECUTOR Subtopic? ^Z
NCP>exit
$