30 Sep
2023
30 Sep
'23
4:17 p.m.
There is a whole bunch of differences. :-)
The whole NTINIT is different (it's replaced by something called
COMINI), there is no NCP, there is a different FAL, NMF, NMV... There is
a NTGNA which is used to fetch nodenames from a remote node. Also
(obviously) no NETGEN.
If you dig through the sources, there is a lot shared, but P/OS also had
a bunch of things that were very Pro-specific.
DECnet for MicroRSX on the other hand is very much like DECnet for M+,
except it's prebuilt and preconfigured.
Johnny
On 2023-09-30 16:10, John Forecast wrote:
As I recall, It was mostly the same. The differences:
- The installation procedure (not 100% sure about this)
- The decna driver is only in the Pro/DECnet kit
John.
--
Johnny Billquist || "I'm on a bus
|| on a psychedelic trip
email: bqt(a)softjar.se || Reading murder books
pdp is alive! || tryin' to stay hip" - B. Idol
On Sep 29, 2023, at 4:45 PM, Robert Armstrong
<bob(a)jfcl.com> wrote:
_______________________________________________
HECnet mailing list -- hecnet(a)lists.dfupdate.se
To unsubscribe send an email to hecnet-leave(a)lists.dfupdate.se Dave McGuire <mcguire(a)neurotica.com>
wrote:
I've gotten a Pro380 running at LSSM, and have just
gotten a DECNA board installed. Can anyone point me to any docs for
Pro/DECnet?
Is it safe to assume that you're running P/OS? Is the P/OS DECnet the
same as the MicroRSX DECnet?
Bob
_______________________________________________
HECnet mailing list -- hecnet(a)lists.dfupdate.se
To unsubscribe send an email to hecnet-leave(a)lists.dfupdate.se