[HECnet] DECSERVER 300 software?

On 2013-05-07 19:41, Sampsa Laine wrote: On 7 May 2013, at 19:13, Johnny Billquist <bqt at softjar.se> wrote: On 2013-05-07 19:00, Sampsa Laine wrote: Yeah, I'll try to get it working, I have NO IDEA what I'm doing though, no documentation that I can find by googling aside from some VMS install guide. Any idea how to reset it to it's factory settings? Didn't I just answer that one? Just hold the button while applying power. Johnny Did that - LED gets stuck on 4 until I release it, then goes to 2. Nothing printed on port 1. I think it might be dead. Two things comes to mind - the fact that the LED is working shows that the basic system is just fine. If something is broken, it would only be port 1 in this case. However, if you have a terminal connected to port 1, and the terminal have modem signalling enabled, it will not print anything. The DS does not activate the modem signals until it has booted. But there are data on the data lines before that... Johnny