22 May
2014
22 May
'14
4 p.m.
On 2014-05-22 14:57, Johnny Billquist wrote:
On 2014-05-22 14:52, Cory Smelosky wrote:
On Thu, 22 May 2014, Cory Smelosky wrote:
With the board in I can get to ODT...but:
QBUS BUS CONTROLLER TEST#1.......................... FAILED
*** FAILED DUE TO UNINITIALIZED Q-BUS MAP, DMA FAILURE OR NON-EXIST
MEMORY.
QBUS BUS CONTROLLER TEST#2.......................... PASSED
QBUS BUS CONTROLLER TEST#3.......................... PASSED
QBUS SINGLE WORD DMA TEST........................... PASSED
QBUS TO FIFO DMA TEST............................... FAILED
*** FAILED DUE TO UNINITIALIZED Q-BUS MAP, DMA FAILURE OR NON-EXIST
MEMORY.
I think the red ECC error light is on, too but the system IS halted.
That sounds bad. What backplane is this sitting in now? And I think the
PMI memory board actually do some internal diagnostics already at power
on, so an error light on is probably not a good sign...
By the way, I hope/assume that you also configured it to start at address 0...
Johnny