[HECnet] Reviving the DECnet on TOPS-10 project

On Wed, 15 May 2013 20:40:01 -0000, you wrote: Disregard, I made some changed to accounting and everything seems operational now. I can't SET KSYS, but every single other thing works! KSYS requires BATCON, so maybe there is something wrong with that. Do you have tweaked your SYS:SYSTEM.CMD file and set the right permissions? It should contain at least something like this to enable batch processing: SET BATCH-STREAM 0 TIME-LIMIT 0:10 SET BATCH-STREAM 1 TIME-LIMIT 0:60 SET BATCH-STREAM 2 TIME-LIMIT 10:100000 START BATCH-STREAM 0:2 And something like this to enable remote DECnet file access: SET FAL-STREAM 0 NETWORK DECNET SET FAL-STREAM 1 NETWORK DECNET SET FAL-STREAM 2 NETWORK DECNET DEFINE FILE-ACCESS DEFAULT-PPN [377777,377777] START FAL-STREAM 0:2 You may want to try these commands at the OPR> prompt before putting them into the SYS:SYSTEM.CMD file. Status of MARLEY TOPS-10 MONITOR at 16:39:09 on 15-May-113 Uptime 43:17, 114% Null time = 114% Idle + 0% Lost, 1% Overhead More than 100% is not very good. It happened to me with a monitor that was unable to keep time: try some DAYTIME commands in a couple of minutes and check if it says the correct wall clock time or not... 9 [OPR] 751 5 ^C 0 This does not seem very good too: it's not detached, it's running nothing, and it's in "^C" state... Maybe it's a stale BATCON process? HTH, G.