On May 24, 2013, at 12:15 PM, Brian Schenkenberger, VAXman- wrote:
...
So, here are a few photographs of some original Ethernet (10base5) bits
I have here -- Etherpipe, AUI cables, and h4000s and h4005s. I put the
camera away before I'd realized that I'd not photographed the tap tool.
I hope you won't be too disappointed in that.
http://tmesis.net/10base5/
Nice. Interesting to see the yellow stuff, I remember that in prototype installations but from what I was told, DEC switched to the brownish/orange teflon jacketed cable for customer shipments. Something to do with flame rating for air handling spaces (i.e., dropped ceiling office areas).
paul
Gregg Levine <gregg.drwho8 at gmail.com> writes:
On Fri, May 24, 2013 at 10:25 AM, Brian Schenkenberger, VAXman-
<system at tmesis.com> wrote:
h vlems <hvlems at zonnet.nl> writes:
Yes, an H4005 was shown but no H4000
I've got some here if you want to see pictures of them.
--
VAXman- A Bored Certified VMS Kernel Mode Hacker VAXman(at)TMESIS(dot)ORG
Well I speak to machines with the voice of humanity.
Hello!
(I did not see the fact that the original thread was cross-posted to
the TUHS list as well as this one, until after the fact.)
Now that I'd be interested in seeing.
It happens that a shop in Manhattan was collecting and attempting to
sell large quantities of Ethernet hardware. And I was the only buyer.
It annoyed them that I was both the only buyer and the only one in the
space who knew what they were.
I wasn't feeling ambitious enough to trudge out the whole lighting "kit
and kaboodle" <http://tmesis.net/Photography/Ummagumma.JPG>, so I took a
few photos on the kitchen table with the 50mm f/1.2 using the available
light from the kitchen window (not much since it's raining). That 50mm
f/1.2 is very good in low lighting but it also has a depth of field that
is thinner than rice paper, so the bokeh is quite evident in the photos
I took. I would have needed the lighting kit to use any of the macros.
I hope to someday build a light box so that I can do proper photographs
of kit like this.
So, here are a few photographs of some original Ethernet (10base5) bits
I have here -- Etherpipe, AUI cables, and h4000s and h4005s. I put the
camera away before I'd realized that I'd not photographed the tap tool.
I hope you won't be too disappointed in that.
http://tmesis.net/10base5/
--
VAXman- A Bored Certified VMS Kernel Mode Hacker VAXman(at)TMESIS(dot)ORG
Well I speak to machines with the voice of humanity.
I'be installed plenty so no thanks Brian...
Van: Brian Schenkenberger, VAXman-
Verzonden: vrijdag 24 mei 2013 16:26 PM
Aan: hecnet at Update.UU.SE
Beantwoorden: hecnet at Update.UU.SE
Onderwerp: Re: [HECnet] Ethernet Marks 40 Years Linking People, Computers in a
Wired World
h vlems <hvlems at zonnet.nl> writes:
>Yes, an H4005 was shown but no H4000
I've got some here if you want to see pictures of them.
--
VAXman- A Bored Certified VMS Kernel Mode Hacker VAXman(at)TMESIS(dot)ORG
Well I speak to machines with the voice of humanity.
On Fri, May 24, 2013 at 10:25 AM, Brian Schenkenberger, VAXman-
<system at tmesis.com> wrote:
h vlems <hvlems at zonnet.nl> writes:
Yes, an H4005 was shown but no H4000
I've got some here if you want to see pictures of them.
--
VAXman- A Bored Certified VMS Kernel Mode Hacker VAXman(at)TMESIS(dot)ORG
Well I speak to machines with the voice of humanity.
Hello!
(I did not see the fact that the original thread was cross-posted to
the TUHS list as well as this one, until after the fact.)
Now that I'd be interested in seeing.
It happens that a shop in Manhattan was collecting and attempting to
sell large quantities of Ethernet hardware. And I was the only buyer.
It annoyed them that I was both the only buyer and the only one in the
space who knew what they were.
-----
Gregg C Levine gregg.drwho8 at gmail.com
"This signature fought the Time Wars, time and again."
h vlems <hvlems at zonnet.nl> writes:
Yes, an H4005 was shown but no H4000
I've got some here if you want to see pictures of them.
--
VAXman- A Bored Certified VMS Kernel Mode Hacker VAXman(at)TMESIS(dot)ORG
Well I speak to machines with the voice of humanity.
Yes, an H4005 was shown but no H4000
Van: Gregg Levine
Verzonden: vrijdag 24 mei 2013 15:58 PM
Aan: hecnet at update.uu.se
Beantwoorden: hecnet at Update.UU.SE
Cc: tuhs at minnie.tuhs.org; dectec-request at dectec.info
Onderwerp: Re: [HECnet] Ethernet Marks 40 Years Linking People, Computers in a
Wired World
On Fri, May 24, 2013 at 8:58 AM, Clem Cole <clemc at ccc.com> wrote:
> I fear a sad part of this slide show is that many of us remember and were
> part of it all. Some of us programmed these machines (I admit that I
> still have some of these pieces in my basement). I was disappointed they
> did not show a "stinger tap." The picture of the Alto shows the first mouse
> the Hawley Labs mechanical mouse (which I miss for its feel). Check out
> the picture of the first Cisco router using Intel Multibus (with a Motorola
> 68k in it) looking so awkward.
>
> http://www.eweek.com/networking/slideshows/ethernet-marks-40-years-linking-…
Hello!
Then you did not notice the one which attempts to describe the widget
attached to the yellow cable. It was a tap who used the stinger
design. It was an interesting slide show, but it did not go into
complete detail.
Charles Spurgeon wrote an excellent book on Ethernet which as it
happens to explain practically everything about the entire ideas
behind it.
-----
Gregg C Levine gregg.drwho8 at gmail.com
"This signature fought the Time Wars, time and again."
On Fri, May 24, 2013 at 8:58 AM, Clem Cole <clemc at ccc.com> wrote:
I fear a sad part of this slide show is that many of us remember and were
part of it all. Some of us programmed these machines (I admit that I
still have some of these pieces in my basement). I was disappointed they
did not show a "stinger tap." The picture of the Alto shows the first mouse
the Hawley Labs mechanical mouse (which I miss for its feel). Check out
the picture of the first Cisco router using Intel Multibus (with a Motorola
68k in it) looking so awkward.
http://www.eweek.com/networking/slideshows/ethernet-marks-40-years-linking-…
Hello!
Then you did not notice the one which attempts to describe the widget
attached to the yellow cable. It was a tap who used the stinger
design. It was an interesting slide show, but it did not go into
complete detail.
Charles Spurgeon wrote an excellent book on Ethernet which as it
happens to explain practically everything about the entire ideas
behind it.
-----
Gregg C Levine gregg.drwho8 at gmail.com
"This signature fought the Time Wars, time and again."
Clem Cole <clemc at ccc.com> writes:
I fear a sad part of this slide show is that many of us remember and were
part of it all. Some of us programmed these machines (I admit that I
still have some of these pieces in my basement). I was disappointed they
did not show a "stinger tap." The picture of the Alto shows the first mouse
96 the Hawley Labs mechanical mouse (which I miss for its feel). Check out
the picture of the first Cisco router using Intel Multibus (with a Motorola
68k in it) looking so awkward.
http://www.eweek.com/networking/slideshows/ethernet-marks-40-years-linking-=
people-computers-in-a-wired-world/?kc=3DEWKNLEDP05242013A&dni=3D60148934&rn=
i=3D24249067
Can't say I disagree with the one comment there either.
--
VAXman- A Bored Certified VMS Kernel Mode Hacker VAXman(at)TMESIS(dot)ORG
Well I speak to machines with the voice of humanity.
I fear a sad part of this slide show is that many of us remember and were part of it all. Some of us programmed these machines (I admit that I still have some of these pieces in my basement). I was disappointed they did not show a "stinger tap." The picture of the Alto shows the first mouse the Hawley Labs mechanical mouse (which I miss for its feel). Check out the picture of the first Cisco router using Intel Multibus (with a Motorola 68k in it) looking so awkward.
http://www.eweek.com/networking/slideshows/ethernet-marks-40-years-linking-…
On Thu, 23 May 2013, Brian Hechinger wrote:
On Thu, May 23, 2013 at 11:57:15AM -0700, Mark Pizzolato - Info Comm wrote:
The latest code at github will now build with VDE support on FreeBSD if the VDE package is installed.
Outstanding, thanks!
I do not read all traffic on this list, so it would be best if folks raised issues with simh at https://github.com/simh/simh/issues
I will remember that for next time.
-brian
I'm going to assume the scripts for autogenerating new configs is running yet? :P
--
Cory Smelosky
http://gewt.net/ Personal stuff
http://gimme-sympathy.org Experiments