> Tony Nicholson <tony.nicholson@computer.org> wrote:
> It [pyDECnet] normally accepts DECnet/MOP and LAT (EtherTypes 0x8003,
>0x8002 and 0x8004) Ethernet frames and tunnels them in IPv4 to another router.
Are you sure? I don't think pyDECnet can tunnel either MOP nor LAT ...
From the pydecnet doc/config.txt file
"--mop: applies only to bridge circuits. By default, only DECnet Phase
IV packets are accepted from and sent to this circuit. If --mop is
supplied, MOP, LAT, and loopback protocol packets are also accepted.
This corresponds to the [lat] section in the bridge.conf file for the
original bridge.c program."
Tony